Symphonia Mini JR
Here's the list of features:
Made in the USA
German top of the line driver technology
Magnesium/ceramic dome tweeter with underhung motor
Low parts count crossover using the following parts:
ERSE air core inductors
Mundorf capacitors and resistors in tweeter signal path
Mundorf resistors
Cardas soldering all point to point from binding posts to drivers
High-end Supra wiring
Cardas patented binding posts
Custom engraved binding post plate and port ring to lower resonance.
Braced baffle and sidewall technology
Flared port for low noise
Proprietary damping material to turn vibration into heat
Size: 8"W X 14"H X 12.75" D (cabinet tapers back and slopes 5 degrees)
Frequency Response: 42hz-25khz
Impedance: 6 ohm
Minimum Power Requirements: 35watt (tube) 50watt (solid state). 86db/2.83v/meter
This speaker is the same as the Symphonia Mini less the expensive custom mounted Accuton Cell tweeter and crossover circuit. We are using an excellent new Eton magnesium/ceramic tweeter, which gets one very close in sonic performance for some substantial savings. We are using the amazing sounding and latest generation Accuton 173mm woofer with resonance control damping dots. You can really hear it dig down deep for a speaker this size, and the midrange is where they truly sing. The transition to the magnesium/ceramic sandwhich dome tweeter is seamless, and here we are using only the best parts in the signal path. The crossovers are hand wired using top tier pure copper wiring with a special coating to prevent oxidation. Best of all, this speaker has gone through many refinements, and we built it so that each design consideration was utilized to its fullest potential. This is evident from the hand crafted sloped front baffle for phase alignment, the point to point soldered crossovers, to the carefully selected and matched transducers.